Publicité
Les langues disponibles
Les langues disponibles
Accessories cleaning
• Unplug the device from the electrical outlet, lower the support post
and tank, turn the device housing over on a covered surface (to
avoid scratching the device), lift the cap from the cleaning hole,
unscrew the cleaning cap counterclockwise with a flat screwdriver
and remove it.
• Rinse the cleaning plug to remove sediment
from the plug with a wire brush, then use the
same method for the interior filling. Rinse off
any remaining dirt and replace the cleaning
cap using a screwdriver, then put the
cleaning hole cap on.
MAINTENANCE
Considering the functions of the garment steamer, in order to prolong
its life, users should perform the daily maintenance as given below.
• After each use, unplug and store the power cord.
• After the device has completely cooled down, remove the unused
water from the water tank ... Clean and dry the water tank then place
it on the base plate.
• Remove the multifunction cap sequentially. Use a cleaning cloth to
clean and dry the brush or spray components.
• Remove the hanger, drying rack and lifting bar, use a cleaning cloth
to clean and dry all parts
• After each use, wait until the device has cooled completely, unscrew
the water release cap and pour out the remaining water from the
heating element. Then clean the heating element and dry it.
• Place all cleaned components in the device packaging. Store the
device in a dry and ventilated place.
EN-18
Publicité
