Installation Requirements - Thera Lite Radiance Mode D'emploi

OPERATING INSTRUCTIONS
WARNING: RISK OF ELECTRICAL SHOCK
• Turn off the power before performing any maintenance.
• Verify that supply voltage is correct by comparing it with the lamp label information.
CAUTION: RISK OF INJURY
• Avoid direct eye exposure to the light source while it is on.
General Safety Information and Precautions
• This product is suitable for indoor use only.
• As with any electrical device, do not use the TheraLite in or near water.
• DO NOT overuse the TheraLite. Overuse may cause irritability, excessive energy or difficulty falling asleep at bedtime.
• It is not necessary to stare into the light. Read, work or talk on the phone during your light therapy session.
• During the first few uses, your TheraLite may give off an odor; this is harmless, will not affect the use, and will quickly disappear.
• Always use in a well-ventilated area away from other heat sources and ensure that air can flow freely around the lamphead when the product is in use.
• To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions and other hazards, read all
warnings and instructions included with and on the fixture box and all fixture labels.
• For residential installation: If you are unsure about the installation or maintenance of the lamps, consult a qualified licensed electrician and check
your local electrical code.
• DO NOT INSTALL DAMAGED PRODUCT!
• The external flexible cable or cord of this lamp cannot be replaced; if the cable or cord is damaged, the lamp will be destroyed.
• To avoid injury or damage to the fitting, ensure that power leads and screws are secure before connecting the power.
• Young children should be supervised to ensure that they DO NOT play with the portable lamp.
• Handle the fitting and/or shade with care to avoid any damage or breakage.
• Select a suitable location away from liquids and hazards.
• Ensure that the fitting does not come in contact with corrosive chemicals, etc.
• To clean, wipe with a damp clean cloth. NEVER soak the fixture with water.

Installation Requirements

1. Select a suitable location for the lamp.
• Ensure it is on a flat and stable surface.
• This product is suitable for indoor use only.
• DO NOT place flammable material near or over the fixture.
• Ensure the fixture is not installed next to any air vents and
is NOT in any moist or damp areas.
2. Take care NOT to pull any electrical wires during unpacking as
this may damage the connection.
3. Check whether the fitting has been damaged during transport.
DO NOT operate/install any product which appears damaged in
any way. Return the complete product to the place of purchase for
inspection, repair or replacement.
DO NOT plug into the main power socket outlet before or during
assembly. Only do so after the portable lamp is fully assembled
and ready to use for the first time.
Installation Directions
1. Remove all packaging material from the product.
2. Select a suitable location for the light fitting. See the
Installation Requirements above.
3. Adjust the head of the lamp to the desired angle.
4. Insert the fixture plug into a properly grounded outlet. Ensure
it is fully plugged in.
5. Use switch to turn the lamp on/off.
Lamphead
Arm
Lamp Base