NewAge Products Home Cabinet Sinks Guide D'installation page 18

Preparing counter top
Using a set square, mark centre line onto the counter top bottom surface with respect to the
sink cabinet as shown. Refer to diagram(B) for Single Bowl Undermount Sink cut-out
2
template. Place the template on the centre line and trace the cut out line as shown. Refer to
the template provided with Sink and take to the countertop supplier to have it cut.
B
UNDERMOUNT CUTTING TEMPLATE - Single Bowl Sink
Positive Reveal
Centre Line
Cutout lines
Back Edge
of Counter top
Front Edge
of Counter top
18
Cutout Measurements - TOP VIEW
Zero Reveal
Negative
Reveal
R 0.39", 10mm
R 0.39", 10mm
30", 762 mm
(For Undermount Sinks)
Zero Reveal
1.5
Positive
mm
Reveal
1.5
mm
Negative Reveal
1.5 1.5
mm mm