Evenflo exer saucer BABY ACTIVE Manuel D'utilisation page 4

Assembling the ExerSaucer
L
M
N
O
N
P
10. Insert a strap O through a strap slot P in the tray
Q
the strap anchor lies flat against the bottom of the tray, as shown. Repeat for the other two straps.
To prevent injury, make sure all three strap anchors are completely
inserted and resting against the bottom of the tray.
8. Press assembled seat L down firmly onto the top of the
tray M until it snaps into place and spins freely.
9. Lean the tray assembly N against one of the pylons,
as shown.
O
N . Pull the strap completely through the tray making sure
WARNING
4
1
1
2
2
3
3
During use, allow the baby's toes only to touch the base. DO NOT allow the baby to stand flat-footed on the base. As baby grows
and becomes more active, raise the tray to the next level so that baby enjoys the most comfortable fit and maximum use of the spin,
and bounce features. Discontinue use when baby can stand flat-footed at the highest setting.
ALWAYS remove baby from ExerSaucer before adjusting. Unlock the adjustment knob
until the desired height is obtained (there are three positions). Turn the adjustment knob to the left to lock in place. Repeat the
adjustment on the other two pylons. Note: Make sure that all three legs are adjusted to the same position.
IMPORTANT: Always make sure the adjustment knobs are locked in position before placing the child in the activity center.
Q
3 "AAA" Batteries
UNLOCK
ADJUST
1
2
A A
3
WARNING
5
Adjusting the Height
LOCK
A
A by turning to the right, then moving
Attaching the Toys
3 "AAA" Batteries