Worx WX255 Notice Originale page 14

keys, nails, screws or other small metal objects,
that can make a connection from one terminal to
another. Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or
burns.
6. SERVICE
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power tool is
maintained.
14
SCREW DRIVER SAFETY WARNING
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
SAFETY WARNINGS FOR BATTERY CELLS INSIDE THE
TOOL
a) Do not dismantle, open or shred cells.
b) Do not short-circuit charging terminal. Do not
store power tool haphazardly in a box or drawer
where charging terminal may short-circuit
each other or be short-circuited by conductive
materials. When power tool is not in use, keep it away
from other metal objects, like paper clips, coins, keys,
nails, screws or other small metal objects, that can make
a connection from one charging terminal to another.
c) Do not expose power tool to heat or fire. Avoid
storage in direct sunlight.
d) Do not subject power tool to mechanical shock.
e) In the event of battery leaking, do not allow the
liquid to come into contact with the skin or eyes.
If contact has been made, wash the affected area
with copious amounts of water and seek medical
advice.
f) Seek medical advice immediately if a cell has been
swallowed.
g) Keep power tool clean and dry.
h) Wipe the charging terminals with a clean dry cloth
if they become dirty.
i) Power tool needs to be charged before use.
Always refer to this instruction and use the
correct charging procedure.
j) Do not maintain power tool on charge when not in
use.
k) After extended periods of storage, it may be
necessary to charge and discharge the power tool
several times to obtain maximum performance.
l) Battery gives its best performance when it is
operated at normal room temperature
(20°C ± 5°C).
m) When disposing of cells, keep cells of different
electrochemical systems separate from each other.