Set Control; Remote Controlled Functioning; Automatic Shut-Off; Uses - Hydas hydro fit WE-999-5HRI Mode D'emploi

7.1 | Set control

Setting switch is found on the back which can be used to control the appliance
when the remote control is not being used. The selected setting is indicated by
the coloured LED light on the handle.
• Press once to turn the machine on and select the lower intensity level: The
LED flashes green.
• Press once more and the machine reaches the higher intensity level: The LED
flashes red.
• Press once more and the machine switches into programme mode: The LED
flashes yellow.
• To turn off the machine, press the switch a fourth time.

7.2 | Remote controlled functioning

You can also select all functions using the remote control. To use the remote
control, point it directly at the infrared detector on the blower.
The remote control is splash resistant. If it falls in the water, take it out immedi-
ately and dry it before using it again.
The selected setting is indicated by the coloured LED lights
on the handle. No LEDs will light on the remote controller.
• Press once to turn the machine on and select the lower
intensity level: The LED flashes green.
• Press once more and the machine reaches the higher
intensity level: The LED flashes red.
• Press once more and the machine switches into
programme mode: The LED flashes yellow.
• To turn off the machine, press the switch a fourth time.

7.3 | Automatic shut-off

The appliance automatically switches itself off after 20 minutes. Should the
unit used again, simply cycle through the entire program and the unit will be
started anew.

7.4 | Uses

• During program modes the air flow will vary between strong and gentle flow.
• The color adapter recieves its energy via the airflow and varies the color
combinations automatically.
• With the button on the light source, this automatic function may be overridden
19