Télécharger Imprimer la page

Celduc okpac SO400200 Mode D'emploi page 3

Publicité

Fig. 2 Courbes thermiques & Choix dissipateur thermique /
12K/W correspond à un relais sans dis-
sipateur monté dans l'air /
12K/W cor-
responds to a relay without heatsink .
6K/W correspond à un relais monté sur
un adaptateur DIN celduc type
1LD12020
6K/W corresponds to a relay mounted
on a DIN rail adaptator like celduc
1LD12020
8V<Ve<30V: Marche démarreur progressif
8V<Ve<30V: Softstarter switch on
Attention ! les relais à semi-conducteurs ne procurent pas d'isolation galvanique entre le réseau et la charge. Ils doivent être utilisés
associés à un disjoncteur avec propriété de sectionnement ou similaire, afin d'assurer un sectionnement fiable en amont de la ligne dans
l'hypothèse d'une défaillance et pour tous les cas où le relais doit être isolé du réseau (maintenance ; non utilisation sur une longue durée...).
Warning ! semiconductor relays don't provide any galvanic insulation between the load and the mains. Always use in conjunction
with an adapted circuit breaker with isolation feature or a similar device in order to ensure a reliable insulation in the event of wrong
function and when the relay must be insulated from the mains (maintenance ; if not used for a long duration ...).
5, Rue Ampère BP30004
Fax +33 (0) 4 77 53 85 51
Sales Dept.For Europe Tel. : +33 (0) 4 77 53 90 21
okpac ®
1 -Itsm non répétitif
tion des protections.
1 -
No repetitive Itsm
to define theprotection (fuses).
2 -Itsm répétitif
Attention : la répétition de ces surcharges de courant diminue la durée de vie
du relais.
2 -
Repetitive Itsm
mal operation , this curve musn't be exceeded. Be careful, the repetition of the
surge current decreases the life expectancy of the SSR.
celduc
r
e
l
a
42290 SORBIERS - FRANCE
Service Commercial France Tél. : +33 (0) 4 77 53 90 20
S/SO400200/C/14/09/2018
Thermal curves and heatsink choice
sans tension réappliquée est donné pour la détermina-
is given without voltagereapplied . This curve is used
est donné pour des surcharges de courant (Tj initiale=70°C).
is given for inrush current with initial Tj = 70°C. In nor-
i
s
Sales Dept. Asia : Tél. +33 (0) 4 77 53
90 19
page 3 / 5F/GB
www.celduc.com

Publicité

loading