Special Safety Instructions - KAN-therm DC 4000 Instructions D'utilisation

of the power tool for operations different from those intended could result in a hazardous sit-
uation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow for safe handling and control of the tool in unex-
pected situations.
5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer. A charger that is suita-
ble for one type of battery pack may create a risk of fire when used with another battery
pack.
b)
WARNING! Use power tools only with specifically designated battery packs
and respectively battery types. Use of any other battery packs may create a risk
of explosions, injury and fire.
c) When battery pack is not in use, keep it away from other metal objects like paper
clips, coins, keys, nails, screws, or other small metal objects that can make a connec-
tion from one terminal to another. Shorting the battery terminals together may cause
burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
e) Do not use a damaged or modified battery. Damaged or modified batteries can behave
unexpectedly and lead to fires, explosions or injuries.
f) Do not expose a battery for fire or high temperatures. Fire or temperatures above 130°C
(265°F) can cause an explosion.
g) Follow all the instructions for charging and never charge the battery or the cordless
tool outside the temperature range specified in the operating instructions. Incorrect
charging or charging outside the permitted temperature range can destroy the battery and
increase the fire risk.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical re-
placement parts. This will ensure that the safety of the power tool is maintained.
b) Never service damaged batteries. All maintenance of batteries should only be carried out
by the manufacturer or authorised customer service points.
1.3

Special safety instructions

The term press jaw also includes main Jaw, press ring and press chain.
KAN-therm DC 4000:
Never hold your fingers or other body parts in the working area of the cylinder or the press jaws.
Remove the battery before carrying out any work on the machine.
If the device is so badly damaged that electric cables or drive parts are exposed, disconnect the
mains plug immediately and contact your service outlet. Unauthorized repair work may result in
the user suffering major injuries or even death.
Only personnel trained in how to use the device may make crimp pipe joints using the KAN-
therm DC 4000.
The machine may only be used with a press jaw inserted into it. The press jaw must be in per-
fect technical condition.
Only start the machine if it is in perfect working order.
Servicing and repair work may only be carried out by workshops authorized by KAN-therm.
Use only suitable press jaws and press fitting systems that have been approved by KAN-therm.
After you have inserted the press jaw check that the bolt is securely locked.
In the event of problems during the pressing process, press the EMERGENCY STOP button.
Check that the pipe joint is secure after you have completed the pressing process.
Imperfect pipe joints must be compressed again using a new fitting.
ENGLISH 15