Shark CORDLESS SV748 N Guide D'utilisation page 4

OPERATING INSTRUCTIONS
5. Carefully lift out the top battery pack
(A) and disconnect the terminals. Then
remove the single battery (B) that is on
the bottom and disconnect the terminal.
(Fig. 8)
Fig. 8
6. Connect the terminals to the single
battery (B) first and insert into the new
unit. Then connect the terminals to the
battery pack (A) taking care to connect
the black leads (-) to the negative
connectors first and the red leads (+) to
the positive connectors second. Place
the new battery (A) into the battery
compartment.
7. Tuck the wiring inside the battery
compartment so that the wiring does
not interfere with the battery
compartment cover when it is replaced.
8. Re-install the battery strap and battery
compartment cover.
WARNING: NEVER use ordinary
batteries for replacement, as these may
leak and damage your vacuum cleaner.
Use only battery pack XBP738 provided
by EURO-PRO Operating LLC for
replacement.
CAUTION: NEVER use the unit without
the battery compartment cover in place.
NOTE: Any other servicing should be
performed by an authorized service
representative.
CAUTION
•
Use only with the battery pack
supplied with the unit.
• Do not attempt to remove the battery
pack from the unit to charge it.
• Never attempt to throw the battery
pack or unit into a fire or incinerate
it.
• Do not attempt to remove or damage
the battery casing.
• Battery must be recycled or
disposed of properly at the end of it's
service life.
• Do not place batteries on metal
surfaces.
• Do not touch metal parts of the
batteries together as the batteries
will overheat.
Wall Mounting Bracket (Optional)
1. Make sure that the intended wall area
for the wall mounting bracket to be
drilled is free from any hidden
electrical wires, water pipes and gas
lines.
2. Select an appropriate place close to a
wall power outlet (120V., 60 Hz).
3. Do not mount near direct sunlight,
near a heat source or outdoors.
4. Select an appropriate drill type for the
material to be drilled.
5. Carefully measure and mark the
location of all bracket holes and then
drill holes and screw the wall
mounting bracket onto the wall.
5
OPERATING INSTRUCTIONS
T R O U B L E S H O O T I N G G U I D E
PROBL EM POSSIBL E RE ASO N
1. Batteries disch arged.
2. Dead battery (battery
wo n't hold cha rge).
HAND VACUUM 3. Contacts between the
W ILL NOT un it and the c harging
OPERATE stand are dirty.
4. No po wer in el ectrical
ou tlet suppl ying
trans former.
1. Dust cup c ontai ner is
full.
HAND VACUUM
2. Dust cup filter needs
W ILL NOT PICK-
cleaning or
UP OR SUCTION
replac ement .
POW ER IS W EAK
3. Unit needs
recharging .
1. Dust cup c ontai ner is
full.
DUST ESCAP ING
2. Dust cup filter is no t
FROM HAND
ins talle d co rrec tl y.
VACUUM
3. Puncture/hole in dust
cup fil ter.
PO SSIBLE SOLUTIO N
1. Charge unit.
2. Replac e batteries .
3. W ipe and cl ean dirt f rom
con tacts .
4. Check fuse or bre aker.
Replac e fuse/reset
breaker.
1. Empty dust cup
con tain er
2. Remove dust cup fil ter
and check for object(s)
in ai r duc t and remove.
Clean or replace dust
cup fil ter.
3. Charge unit.
1. Empty dust cup
con tain er.
2. Re view d ust cup filter
ins tallation instructions.
3. Replac e dus t cu p fi lter.
6