Service And Maintenance; Service Parts; Maintenance Procedures - McQuay J Serie Manuel D'installation

Service Parts

1. Remove any dust adhering to the filter by using a vacuum cleaner or wash in
Indoor air filter
2. Rinse the filter well and dry before placing it back onto the unit.
3. Do not use gasoline, volatile substances or chemicals to clean the filter.
1. Clean any dirt or dust on the grille or panel by wiping it with a soft cloth
Indoor unit
2. Do not use gasoline, volatile substances or chemicals to clean the indoor
1. Open the front panel.
• Hold the panel at the recesses on the main unit
(2 recesses on right and left sides) and lift it until it
stops.
2. Remove the front panel.
• While lifting the front panel further, slide it to the right
and pull it to the front side. The left rotating shaft is
detached. Slide the right rotating shaft to the left and
pull it to the front side to remove it.
3. Attach the front panel.
• Align the right and left rotating shafts of the front
panel with the grooves and push them all the way in.
• Gently close the front panel. (Push both ends and the
center on the front panel.)
• Do not touch the metal parts of the indoor unit. It may cause an injury.
• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
• For cleansing, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing
compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
When The Unit Is Not To Be Used For An Extended Long Period Of Time
Operate the unit for 2 hours
with the following setting.
Operating mode : cool
Temperature : 30°C/86°F
Acson IM-WMJ-0109(0).indd 13
All manuals and user guides at all-guides.com

SERVICE AND MAINTENANCE

Maintenance Procedures

lukewarm water (below 40°C/104°F) with a neutral cleaning detergent.
soaked in lukewarm water (below 40°C/104°F) and a neutral detergent
solution.
unit.
Rotating
shaft
CAUTION
Remove the power plug.
If you are using an independent
electric circuit for your unit, cut
off the circuit.
Remove the batteries in the
remote control.
1-13
Period
At least once every 2
weeks.
More frequently if
necessary.
At least once every 2
weeks.
More frequently if
necessary.
Recess on
main unit
2009-4-8 9:10:13