Getting Started - Aluratek ADMPF110 Manuel D'instructions

Getting Started

Step 1:
Remove the protective film covering the LCD.
Step 2:
Remove the plastic insulator from the battery on the remote control.
Operations
Set-Up
STEP 1:
Plug the power adapter in then turn the power switch on.
STEP 2:
Please insert your memory card (SD, MMC, CF, MS or XD) at this time. You may also insert a USB
thumb / flash drive into the on-board USB 2.0 port which will be detected automatically. Slideshow will
start automatically when the card is inserted. (The slideshow will start from the internal memory if no
memory card is detected)
12