General Description - Arnica BORA 4000 Manuel D'utilisation

ARNICA BORA 4000
DRY VACUUM CLEANER WITH WATER FILTER
Thank you for choosing our product. This instructions manual has
been prepared for you to achieve complete satisfaction and maximum
performance from your product.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE
AND KEEP THE MANUAL FOR FUTURE REFERENCE.
CONTENTS
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
II. GENERAL DESCRIPTION
III. TECHNICAL SPECIFICATIONS
IV. PREPARING FOR USE
V. USING THE APPLIANCE
VI. CLEANING & MAINTENANCE
I. IMPORTANT SAFETY & USAGE INSTRUCTIONS
• Unless management and supervision regarding the device are
ensured by a person responsible for safety of the devices, this
device isn't designed to be used by physically and mentally
disabled people (including children) or by people who are lack of
experience and knowledge.
• Children must be supervised in order to ensure keeping them away
from the device.
• Check if the voltage indicated on the type plate sticker (located
under the wheel group) corresponds to the local mains voltage
before you conect the appliance.
• The appliance should only be connected to power outlets which
are suitably with minimum 10 Amp fuse.
• Do not insert the mains plug into the wall socket until the appliance
is completely ready for use.
• Always remove the mains plug from the wall socket when you are
not operating the appliance.
• Appliance musn't be used if the cord or plug is damaged, if any
defects are present of if you have dropped the unit or have broken
any of its parts. I such cases, you must take it to a service center
to be checked, repaired or adjusted.
• Do not allow the appliance to pass over the cable as this may
damage the insulating shield.
• Keep the appliance out of reach of children
• Never use appliance without the foam filter
• Never immerse the motor unit in water
• Do not attempt to use the appliance if it appears to be defective.
• Always switch the appliance off after use and remove the mains
plug from the wall socket.
• Always empty, clean and dry container after wet use. Let the
appliance suck in dry air for few minutes to dry the inside of the
tubes and hose. This prevents unpleasent smell and prevents the
paper dust bag from becoming wet.
• Do not point the hose at the eyes or ears nor put it in your mouth
when the appliance is switched on.
• Take particular care when cleaning stairs.
• Switch off immediately in the event of leaking liquid .
• Use only original accessories and spare parts to ensure the perfect
performance of your cleaner and to benefit from the guarantee.
• For repairs or spare parts, contact your local service agents.
WARNING: Never use the appliance to clean up flammable or
explosive solvents, object soaked with such solvents, explosive dusts,
liquids such as petrol, oil, alcohol, thinners and objects that are hotter
than 60 oC, as this will cause a serious explosion and fire hazard! The
appliance must not be used near flammable substances and must
not be used to clean up health endangering dust.
WARNING:
Only perform dry vacuuming with your vacuum cleaner.
II. GENERAL DESCRIPTION
Main parts of the appliance are shown as follows (Figure 1)
A. MOTOR UNIT
This group contains motor, switch and operating units on. Top of
this group, there is a HEPA FILTER which filters dust and other
particles from blowing air.
A1. ON-OFF switch
A2. Cord rewinder button
A3. Hepa Filter
A4. Hepa Filter housing cover
A5. Suction inlet
A6. Body handle
A7. Wheels
A8. Clamp housing
B. CONTAINER GROUP
Container Group is for collecting dust and dirty water. This group
is placed on the Body group.
B1. Transparent Water tank
B2. Cover of the Transparent Water tank
B3. Handle of the Transparent Water tank
B4. Water Filter Body
B5. Water filter tube
B6. Water filter tube loophole
C. THE HOSE GROUP
This group contains suction hose with hand grip and suction tubes.
Suction nose is connected to container group by inserting the suction
hose into the suction inlet. Suction tubes are connected to hand
grip if necessary. Handgrip contains a manual sliding for regulating
suction power. Hose group can be placed onto the motor unit by
the help of hanger.
C1. The elastic suction hose
C2. Telescopic pipe
C3. Main brush
C4.Turbo brush
D. ACCESSORIES GROUP
There are various accessories for different cleaning purposes.
D1 - Accessories Holder
D2 - Crevice Nozzle
D3 - Round Nozzle
D4 - Small Nozzle
D5 - Parfume
6