osann COCO Mode D'emploi page 16

16
EN
5.1 Installation without Isofix base
1
3
3
2
1. Pull the safety belt of the vehicle and carry out the lap belt under the side guide (1) right and
left.
2. Pull the shoulder strap along the back of the infant carrier through the guide (3).
3. Close the seat belt of the vehicle and make sure that it is tightened.
5.2 Installation with Isofix base (optional)
Adjustment knob of the stand
1. Pull up on the stand adjustment lever and at the same time press the adjustment on the
stand itself to bring it to the last position.
2. Gently push the base into the Isofix anchorage of your car to connect the base to the car.
3. Check if the Isofix anchorage is correctly installed. The color must change from orange to
green.
4. Push the base back toward the back of the car so that the baby carrier is as close as possible
to it.