AGA marvel MO24BN Série Instructions D'installation, D'utilisation Et D'entretien page 15

Optional CO tank external mounting bracket:
2
The optional mounting bracket is designed to hold the 5#
CO cylinder that comes with the beer dispenser. Larger
2
cylinders may be purchased from a third party and mounted
externally. Use the hole port on the rear of the cabinet to
run the CO line to the keg.
2
Many options are available for mounting the CO
side of the beer dispenser to gain additional cold storage
space inside.
Secure the optional external mounting bracket on the
back of the beer dispenser (this is ideal for mobile
units) or mount within adjacent cabinetry (ideal for
undercounter built-in units:
Mount the (4) screws (#10-32 x
screws) provided with the bracket in the rear of the appli-
ance, see Figure 36. Do not completely tighten. Place the
keyhole slots in the flanges of the bracket over the four
screws and tighten them to secure the bracket to the back
of the cabinet. The bracket can also be fastened to adja-
cent cabinetry using the provided #10 x
Mark the hole locations where required using a pencil and
the slots in the mounting bracket. Drill appropriate pilot
holes (depending on the material you are mounting to) and
secure the bracket per the above instructions.
NOTE
Consider the length of the red air line when choosing a
place for the CO tank. The red air line supplied is 4 feet
2
(1.2 meters) long.
With the gauges mounted to the CO
the mounting bracket.
Remove the foam plug from the hole port as shown in Fig-
ure 36, and feed the red CO
out the coil cover on the inside of the cabinet. Connect the
red CO line to the keg coupler.
2
Reseal the hole in the back of the cabinet with the foam
plug. See Figure 37.
CAUTION
!
If the CO tank is placed on the floor it must be secured in
2
the upright position with a chain or other means to prevent
it from being tipped over.
USING YOUR BEER DISPENSER
tank out-
2
⁄ " flathead machine
3
4
⁄ " wood screws.
3
4
tank place the tank in
2
line through the rear wall and
2
Remove foam plug
from hole port
Mounting
bracket
Reseal hole
around tubing with
the foam plug
15
Screws (4)
Figure 36
CO tank
2
placed in the
bracket
Figure 37