AGA marvel MO24BN Série Instructions D'installation, D'utilisation Et D'entretien page 13

Rear of counter top
1
(3.5 cm)
typical
Diameter
to suit
counter
top depth
⁄ " (6 mm)
1
4
25 ⁄ "
5
16
radii,
(64.3 cm)
typical
(15.6 cm)
Figure 31
CAUTION
!
The cutout dimensions shown in Figure 31 are based on
a 25 ⁄ " (64.3 cm) deep counter top. Your counter top may
5
16
be different than this and require other front to back dimen-
sioning. Refer to the product dimensions on pages 6 and 7
when determining the required dimensions.
Grate from top of
beer dispenser
Counter top
sump from
literature pack
Figure 32
USING YOUR BEER DISPENSER
⁄ "
3
8
1 ⁄ (38 mm)
1
2
Diameter
2 ⁄ "
7
8
(7.3 cm)
4 ⁄ "
1
4
(10.8 cm)
6 ⁄ "
3
6 ⁄ "
1
8
8
(16.2 cm)
12 ⁄ "
1
4
(31.1 cm)
Tower
4. If you are installing your keg refrigerator under a coun-
ter you will need to drill 5 holes in the counter top to
mount the tower. The first hole is a 1
located at the center of the tower for the beer line, lo-
cate approximately 13
of the counter top (based on a counter top depth of
25 ⁄ "). Next drill the 4 tower mounting holes per the di-
5
16
mensions in Figure 31. The hole diameter is dependent
on the counter top material and if screw anchors are
required. The screws supplied are in the literature pack
and are a #10 x 1" type AB stainless steel screw. Mark
and cut the rectangular cutout for the drain sump. After
the holes are drilled and the keg refrigerator is in place
under the counter top feed the beer line through the
tower gasket, the 1
hole in the top of the keg refrigerator. Mount the tower
to the counter top with the 4 screws provided. Place
the counter top drain sump, from the literature pack, in
the rectangular hole with the radius cutout to the rear
around the tower and place the grate in the sump.
5. Mount the regulator to the CO
Note that the regulator has left hand threads and has to
be turned counterclockwise to tighten. Tighten with the
adjustable wrench or the 1
6. Connect the red air line(s) from the regulator to the
large air line fitting on the keg coupler with a large
hose clamp (connection
7. Connect the clear beer line from the tower to the small
air line fitting on the keg coupler with a small hose
clamp (connection
8. Locate the CO tank in the corner of the refrigerator as
2
shown in Figure 34 and secure with the chain. Close
the faucet handle on the tower.
13
⁄ " diameter hole
1
2
⁄ " (34.3 cm) from the front edge
1
2
⁄ " hole in the counter top and the
1
2
tank (connection
2
⁄ " open end wrench.
1
8
).
C
).
A
Figure 33
).
B