Publicité
Find Quality Products Online at:
Operating Instructions
■
Scribing face: Close the jaws and press the "zero" button (12) to reset the
display to zero (fig. 6A). Adjust the scribing reference face (10) to the part
reference, slide the cursor (5) to the chosen measurement, lock it using the
locking screw (8) and then scribe (fig. 6B).
■
Measurement for comparison: Using a standard, press the "zero" button
(12) to reset the display to zero (fig. 7A). After that, start measuring; the
variation will be shown on the display. Dimensions smaller than standard
will be indicated with a negative sign (fig. 7B).
■
Measurement of center to center between holes or identical pins: Using
one of the holes or one of the pins as a reference, press the "zero" button
(12) to reset the display to zero (fig. 8A & 9A). After that, start measuring;
the center to center value will be shown on the display (fig. 8B & 9B).
■
Measurement of wall thickness: Using a part as reference place the caliper
and press the "zero" button (12) to reset the display to zero (fig. 10A).
Next, measure the depth using the depth measuring rod (3). The thickness
will be shown on the display (fig. 10B).
■
Measurement in places where reading is difficult to obtain: Measure and
press the "zero" button (12) to reset the display to zero (fig. 11A). After
that, close the jaws; the measurement will be shown on the display with a
negative sign (fig. 11B) (Do not consider the sign).
8
GlobalTestSupply
www.
.com
sales@GlobalTestSupply.com
Publicité
