OHAUS Valor 1000 Serie Guide De Démarrage Rapide page 3

Valor TM 1000 Series
1. SAFTY INFORMATION
Definition of Signal Warnings and Symbols
Safety notes are marked with signal words and warning symbols. These show safety
issues and warnings. Ignoring the safety notes may lead to personal injury, damage to the
instrument, malfunctions and false results.
WARNING For a hazardous situation with medium risk, possibly resulting in severe
injuries or death if not avoided.
CAUTION For a hazardous situation with low risk, resulting in damage to the device or
the property or in loss of data, or minor or medium injuries if not avoided.
ATTENTION For important information about the product. May lead to equipment damage
if not avoided.
NOTE For useful information about the product.
Warning Symbols
General
hazard
Safety Notes
CAUTION: Read all safety warnings before installing, making connections, or
servicing this equipment. Failure to comply with these warnings could result in
personal injury and/or property damage. Retain all instructions for future
reference.
Before connecting power, verify that the AC adapter's input voltage range and plug

type are compatible with the local AC mains power supply.
 Do not position the equipment such that it is difficult to reach the power connection.
Make sure that the power cord does not pose a potential obstacle or tripping hazard.

Operate the equipment only under ambient conditions specified in these instructions.

The equipment is for indoor use only.

Do not operate the equipment in wet, hazardous or unstable environments.

 Do not allow liquids to enter the equipment.
 Do not load the equipment above its rated capacity.
Do not drop loads on the platform.

Do not place the equipment upside down on the platform.

Use only approved accessories and peripherals.

 Disconnect the equipment from the power supply when cleaning.
Service should only be performed by authorized personnel.

WARNING: Never work in an environment subject to explosion hazards! The
housing of the instrument is not gas tight. (explosion hazard due to spark
formation, corrosion caused by the ingress of gases).
CAUTION: Battery is to be replaced only by an authorized Ohaus service
dealer. Risk of explosion can occur if the rechargeable battery is replaced with
the wrong type or if it is not properly connected. Dispose of the rechargeable
battery according to local laws and regulations.
Intended use
This instrument is intended for use in businesses and light industry. It shall only be used for
Explosion
hazard
Electrical shock
hazard
EN-1