NOSTALGIA PRODUCTS Vintage CCP600 Instructions Et Recettes page 9

Assembly of Base Support
1. Attach #6 Handle and Screws to Storage Compartment door.
2. Push Handle (E) attaches onto the Storage Compartment
(C) using all of the supplied #1 Screws.
3. Insert Cross Bar (J) into the square inserts on the inside of Base Support (I) and
secure from below with two #2 Bolts and two #4 Flat Washers. Insert the Leg
Assembly (K) into the square inserts between the ends of the Base Support (I)
and fasten from inside with two #3 Bolts, two #4 Flat Washers and two #5 Nut
Caps. Also secure from above with two #2 Bolts and two #4 Flat Washers.
4. Assemble Base Support (I) into the bottom of the Storage Compartment
(C) and secure with four #2 Bolts and four #4 Flat Washers. Attach
#6 Handle and Screws to Storage Compartment (C) door.
7