YORKVILLE Elite Legacy Serie Manuel De L'utilisateur page 4

jacks are connected
in parallel, you can use
them to daisy-chain
other LS800Ps or full
range enclosures.
Note: the Mono
Blend Input is
intended for Line
Level signals only!
For normal operation,
connect the LS800P
just like an ordinary
speaker along with the
full range enclosures.
Set the Input Level
switch to Speaker if
the signal is coming
directly from a power
amplifier, 'powered' mixer, or other powered
source. If the LS800P is receiving the signal
from a non-powered mixer, a line level signal
processor (as in an equalizer) or another line-
level source, set the input switch to Line.
The LS800P may be plugged in before or
after the full range enclosure. The LS800P
does not alter the signal to the daisy chained
enclosures and will not draw any power from
the host amplifier/processor driving them.
Also, note that an external crossover is not
necessary when using the LS800P.
As well as accommodating full range
enclosures, the Link jacks allow many LS800Ps
to be connected in a string (parallel). There
is no practical limit to the number of LS800Ps
that may be connected together.
AT HIGH POWER LEVELS WHEN THE LIMITER IS OPERATING INCREASING THE SUBWOOFER LEVEL CONTROL WILL NOT
INCREASE THE OUTPUT. DO NOT INCREASE SETTING WHILE OPERATING AT HIGH LEVELS.
Note: The LS800P built-in stand mounting adapter can be used with Yorkville SW-Teletube accessory to support our
E160 cabinets. The support tube can be adjusted up to it's full 5-foot 4-inch extension safely as long as the LS800P
LS800P
INPUT LEVEL
CLIP
LINE SPKR
LIMIT
PWR
Yorkville
INPUT
NOTE: MONO BLEND INPUT
IS LINE LEVEL ONLY!
MONO BLEND INPUT INPUT
is not inclined mor than 10° (10-degrees).
WARNING: Larger or heavier cabinets shound not be used!
2
HF ROLLOFF
SHAPE FREQUENCY
dB Hz
12 90 150
LOUD DEEP
LINK
OUTPUT
OUTPUT
7. Protection
The LS800P has circuitry to prevent clipping,
over current and over excursion. At high
levels the limiter will limit the gain of the
LS800P and hence if the user attempts to set
the subwoofer level control at a high level,
the resulting setting will be incorrect. The
level control should be set while operating
at low levels (under 10 watts). If the level
control is set too high due to setting it at high
operating levels the input circuit will clip and
the dynamics of the bass will be lost. The Red
Clip indicator will signify when this occurs. This
can happen without audible distortion since
the filters will filter out the distortion.
6. Mono Blend
Input Jack
The Mono Blend Input
jack enables you to
connect a secondary
line level signal to
the system without
externally summing the
two signals (e.g. Left
and Right). This is helpful
when you are adding a
single LS800P to a stereo
system. By using this
input for your secondary
signal, it is blended
internally with the Link
input but isolated to
prevent interaction of
those signals.