Applications - Lavor SMX-R 80 3-36S Notice D'utilisation Et D'entretien

electric sources.
• Only use or replace electrical supply cables
for this unit which correspond to the types
indicated by the manufacturer. Refer to
the parts' list for the part number and type.
• Switching-on procedures may produce
brief voltage drops. In the case of insuf-
ficient power source conditions, interfer-
ence to other devices may arise. No inter-
ruptions are to be expected in the case of
power supply resistance of less than 0,15
Ohm.
• Never touch the mains plug with wet
hands.
• Do not run over, crush or pull the power
supply cable or extension cord, otherwise
it may be damaged.
• Protect the cable from heat, oil and sharp
edges.
• Regularly examine the power supply line
for damage such as cracking or ageing.
If damage is discovered, the line must be
replaced by an authorized service centre
before any further use.
• Check that the vacuum cleaner hasn't
been damaged in any way
• Never turn on the machine if it is faulty or
if you suspect it is faulty
• Check that the switch isn't worn or dam-
aged
• Do not approach the suction intake of the
machine with unfastened or broken gar-
ments that could easily be sucked into the
machine
• Check that the filters are present and ef-
ficient
• Make sure that the filters are installed cor-
rectly and in full working order, always
observing the regulations in force in the
workplace
• Do not carry out repairs without the man-
ufacturer's authorization
• Never use gasoline, solvents or other am-
mable liquids for cleaning; only proper de-
tergents should be used for cleaning
• Never move the machine by pulling the
power cable or flexible hose
• Never direct the opening of the machine
or the flexible tube towards people or ani-
mals
• Protect the machine from the rain
• Check that the machine is connected to a
power source with the correct voltage in-
dicated on the registration plate
• Make sure that the power cable has no
wear or damage. if replacing the cable, al-
ways replace it with another of the same
specifications as the original one: cables
that are not approved or of inferior quality
may overheat and cause serious injury to
the user
• Make sure that the machine is connected
to an appropriate power source in full
working order (check the presence of a
fully functional grounding socket)
• Never allow unauthorized personnel to
use the machine
• Make sure that all safety devices are in full
working order before turning on the ma-
chine
• Never cover the vacuum cleaner during
use

APPLICATIONS

• Before use, check that the unit and oper-
ating equipment, in particular, the power
supply cable and the extension cord are in
the perfect condition and are safe to oper-
ate. Do no use this unit if not in perfect
condition.
• Never use it to vacuum explosive or com-
bustible gases, liquids, or dusts, or undi-
luted acids and solvents. Substances to
avoid also include petrol, paint thinner
and fuel oil which could form explosive
fumes or mixtures in contact with the tur-
bulent air under vacuum. In addition, the
list includes acetone and aluminium and
magnesium dusts. These substances can
also corrode the parts of the unit.
• Do not vacuum burning or glowing ob-
jects or open flames.
EN
13