Function Operation - Nemox gelato 4K TOUCH Mode D'emploi

Function Operation
Pause function 1 TAP L.1
activation
Pause function 1 TAP L.1
deactivation
Manual TAP L.3
activation of 1 x 3"
the storage
function
Selection of the TAP L.3
storage cycle
Return to the TAP L.3
production 1 x 3"
cycle from the
storage phase
Turning off the TAP L.1
machine 1 x 2"
PANEL AND FUNCTIONS OF THE Gelato 4K TOUCH
ENGLISH
Description
Press the START L.1 key
Pause function can be activated during the
production or storage phase. When the
Pause function is active, this is signaled by
a beep every 10 seconds.
NOTE: Pause function starts
automatically if the lid is kept open for
more than 4 seconds. (see section Gelato
4K TOUCH, the LID).
WARNING: the Pause lasts up
to 10 minutes after which the
machine turns off automatically.
5 beeps signal the turning off.
Press the START L.1 key to exit the pause
function and return to the production or
storage phase.
Press the L.3 key for 3 seconds.
Activation of the storage
Selectable at any time during the ice
cream production phase or during the
pause.
WARNING: Storage lasts up
to 8 hours. After this time,
the machine will turn
automatically. 5 beeps signal
the turning off.
Press the L.3. key
If you want to manually select the
density during the storage phase,
repeatedly press the L.3 key to select a
different density to the default.
The larger LEDs indicate a higher density.
Smaller LEDs indicate a lower density.
Press the L.3 key for 3 seconds.
Activation of the production cycle.
Selectable at any time during the ice
cream storage phase.
Press the L.1 key for 2 seconds.
Stop all functions.
7
Led and sound
Switching from the production to the
pause phase
- Led L.1 turned on
- TIME LINE Led L.2 flashing
- Pause start audible signal (1 beep)
- Audible signal every 10 seconds (1 beep)
Switching from the storage to the
pause phase
- Led L.1 turned on
- Led flashing on the STORAGE bar
- Pause start audible signal (1 beep)
- Audible signal every 10 seconds (1 beep)
Reaching the time limit:
- Led L.1 subtle lighting.
- Machine turned off audible signal (5 beeps)
Exit pause phase
- Led L.1 turned on
- Led goes from flashing to steady.
- Blade re-start audible signal (2 beeps)
Manual activation of the storage
phase. - Led L.1 turned on
- Led L.2 TIME LINE all turned on
- Led L.3 SEL turned on
- Led L.4 STORAGE turned on
- Storage start audible signal (3 beeps)
Reaching the time limit:
- Machine turned off audible signal (5 beeps)
off
Selecting the storage density
- Led L.1 turned on
- Led L.4 STORAGE lights up corresponding to
the selection made.
- Led. TIME LINE L.2 all turned on
Return to production stage
- Led L.1 turned on
- TIME LINE Led L.2 light up gradually.
- Led L.3 SEL turned off.
- Led L.4 STORAGE turned off
- Blade movement audible signal (2 beeps)
Turning off the machine
- Led L.1 subtle lighting.
- Machine turned off audible signal (5 beeps)