HAMPTON BAY 58913 Mode D'emploi page 11

Assembly - Hanging the Fan (continued)
Mounting the fan-motor assembly
8
(standard mount)
□
Align the locking slots of the canopy (C) with the two screws (II)
in the mounting bracket (A). Push up to engage the slots and
turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two canopy screws (HH) (saved from Assembly Step 1
"Prepairing for mounting") into the holes in the canopy (C) and
tighten firmly.
□
Install the decorative canopy ring (FF) by aligning the ring's slots
with the screws in the canopy (C). Rotate the ring clockwise to
lock in place.
Assembly - Attaching the Fan Blade
1
Attaching the blade to the motor
□
Attach a blade (F) to the fan motor housing (E) by inserting the
blade (F) into the slot in the side of the fan motor housing (E)
until it stops. The locking clip (LL) will click when the blade is
correctly installed. Ensure the blade is snapped into locking
clip (LL) completely by pulling the fan blade away from the
motor housing.
□
Repeat these steps for the remaining blades (F).
Removing the blade from the motor
□
To remove the blade (F) from the motor housing (E), squeeze
the tabs of the locking clip (LL) towards each other and pull the
fan blade away from the motor housing.
□
Repeat these steps for the remaining blades (F).
A
LL
11
Please contact 1-855-HD-HAMPTON for further assistance.
II
B
HH
FF
C
D
E
E
LL
F
HOMEDEPOT.CA