How To Use; Disposal Of The Product - CUOGHI WMD 80 Manuel D'instructions

How to use

Start-up
When the plug is connected the display D blinks for 5 seconds
and shows the last functioning mode selected: then, if the func-
tioning mode is different to zero, the display stops blinking.
Shutdown
To switch off the dehumidifier push button T1 until the value
displayed is 0. When zero is selected both the green light S1 and
the display D blink.
The defrosting cycle
The electronic board automatically performs the defrosting cycle
to melt the ice and keep the air flow efficient even at lower tem-
peratures. The yellow light S3 switches on when the defrosting
cycle is started.
Maintenance
The dehumidifiers of the WMD series need no particular main-
tenance. It is advisable to dust them and keep the air intake and
outlet grids clean. Contact your dealer if it should function badly
or break down. In the event of damages the cable must be re-
placed with a similar one only by experienced and qualified staff.
ATTENTION: Before doing anything on the appli-
ance disconnect the power supply by unplugging the
machine.
How to clean the filter
The filter can be cleaned with a vacuum cleaner or with water: in
this case dry it before assembly.
Keep the air filter clean, especially in dusty rooms: a
dirty filter reduces the air flow and efficiency of the
dehumidifier.
How to remove the air filter
Remove the front grid G, then remove the air filter F.
Pic.8 – The air filter.
How to put the air filter on
Place the air filter F on the inlet grid, then mount the front grid
G.
12
Storage
• Keep the appliance in a room with a temperature between
–25°C and +55°C.
• When the appliance is still packed follow the instructions on
the box.
• Do not place other heavy material on the box.
Checks to carry out before and
after a long period of inactivity
Before
• Disconnect the plug.
• Cover the machine to protect it from dust.
After
• The fan must turn freely without gripping;
• Start the machine following this manual's instructions.

Disposal of the product

The crossed-out wheelie bin symbol indicates that the product
must be collected separately from other waste at the end of its
useful life.
The user must therefore take the appliance at the end of its useful
life to a special centre for electrical and electronic waste collec-
tion or hand it back to the retailer upon purchase of a new prod-
uct of an equivalent type, on a one-for-one basis.
Proper segregated waste collection of old appliances for subse-
quent recycling, treatment and environmentally compatible dis-
posal helps avoid possible negative effects on the environment
and health and favours recycling of the materials the product is
made of.
ENGLISH
M1252-0_draft-2