Indel B BI36HOMEPLUS Mode D'emploi page 20

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Using the wine cellar
Operation of a cellar with a double or a
GB
single temperature zone
The cellar has been set up so as to work
with two different temperature zones, or
else – depending on the needs of the cus-
tomer – with a single temperature zone.
In order to work at double temperature,
one must place the black bottle holder grill
on the guides of the fourth shelf (counting
top down), then set the temperature you
want in the upper area. Remember that the
temperature of the lower area, once you
have reached the temperature you want,
will be higher than the one you set by about
6 degrees Celsius (the temperature of the
lower area cannot be set separately).
Note: to preserve the wines properly, we
suggest you set the temperature of the top
compartment thermostat at 7° C (serving
temperature for white wines), thus obtaining
14° to 15° C in the bottom compartment.
For single temperature area operation, you
must remove the black bottle holder grill
and replace it with the accessory grid (of the
same kind of the other wood colour ones,
already installed) . We suggest you keep
the unused grid in a dry and cool place, in
order to prevent it from being damaged by
humidityor by other atmospheric agents, as
this would make it unusable in the future.
8
All manuals and user guides at all-guides.com
Temperature control
Top area:
the temperature of the top area can be seen
at any time on the control display
Bottom area:
to see the temperature of the bottom area,
press the button
perature of the bottom area will be displayed
for three seconds (shelves 5 and 6).
If there is a single temperature area, you
only need to look at the temperature shown
on the control display, without pressing any
button.
Figure: Control Panel
Taking out the wooden shelves
Take the shelves out slowly, pulling them
towards yourself until the end of their stroke.
Take out or put back the bottles and then
push the shelf back in until it stops at the
back.
Should you want to take the shelf out com-
pletely in order to make a different layout
for storing the bottles (see page 6), pull the
shelf firmly towards yourself. Remember to
take off the bottles before doing so.
! Under no circumstance must you take out
more than one sliding shelf at a time.
BI 36 HOME PLUS-BI 36 HOME 2T PLUS_13-09-2017
one second. The tem-

Publicité

Table des Matières
loading

Produits Connexes pour Indel B BI36HOMEPLUS

Ce manuel est également adapté pour:

Bi36home2tplus

Table des Matières