Gira ST55 Mode D'emploi page 34

Assembly and installation
3.2 Step 2
N 1 L
N
1
F
L
230 V~/50 Hz
• Attach the supply line to terminal L, N on the back of the display unit (1).
If desired an extension (button, switch or motion detector) can be attached to terminal 1.
• Insert loudspeaker line side-wise into the socket of the display unit (2).
• Snap display unit into the base (3).
• To disassemble the display unit, snap out the display unit by pressing lightly and take out.
34
2
Notes:
– During the installation to the mains
(230 V/50 Hz~) the electrical system
has to be without voltage.
– Secure the power line (230 V~/50 Hz)
with a circuit breaker (max. 16 A).
– Please note! Ensure phase balance of the
3
extension!
GB