Uline H-6861 Manuel D'installation page 2

Figure 2
9
Figure 3
8
Tension Knob
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
10
11
2. Align armrest with holes on bottom of seat cushion.
Use four 5/16 x 1⁄" screws (9) to attach. Repeat on
opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 5/16 x 1" screws (8) to attach. (See Figure 3)
4. Align back support mounting plate with holes on
bottom of seat cushion. Use two 3/8 x 1/" screws
(10) to attach the mounting plate to the mechanism.
Use two 3/8 x 1/" screws (10) with two washers (11)
to attach the mounting plate directly to the seat
cushion. (See Figure 4)
0721 IH-6861