Aqua Optima Aurora Manuel D'utilisation page 6

4. How to use
1. Fill water tank to the "MAX" mark; water will flow through
the filter at a set rate and may take some time due to the
action of the filter cartridge.
2. Adjust the height of the drip tray to
accommodate the size of the mug
used. Ensure the drip tray is fully
engaged with the appliance. There are
3 height options (A).
3. Place mug or glass on drip tray (B).
4. Press the On/Off button. The On/
Off button will light up blue and the
appliance will be locked (C).
5. Press and hold the lock button for
3 seconds to unlock the appliance.
The lock button will change from red to
white (D).
6. Press the up or down button to select
the desired temperature and volume
settings (E).
7. Press the dispense button to start
dispensing. One beep at the start. (F)
8. The dispense button will fade in and
out whilst dispensing and beep twice
once complete.
Note:
• To stop the cycle at any time press the dispense button.
Once the cycle has stopped it cannot be continued. A
new cycle must be started.
• The user interface will automatically lock after 60
seconds if no actions are performed or can be manually
locked by holding lock button for 3 seconds.
• Sound - all button sounds can be turned off (not sound
in 6. & 7.) in How to use guide, section 4.) by pressing and
holding the temperature down arrow and the volume up
arrow for 3 seconds in the locked mode.
• Lock – the automatic lock can be turned off by pressing
and holding the temperature up arrow and the volume
down arrow for 3 seconds in locked mode. Manual locking
will still be active.
• The chilled temperature setting
the appliance is chilling the water and will light up white
when the water is chilled. At first use the chiller takes
around 40 minutes to fully cool down the water (can vary
depending on the incoming water temperature).
• The refill icon will turn orange when the water tank needs
refilling.
• The filter icon will turn orange when the filter needs
replacing, at 100L usage, follow the filter preparation and
replacement instructions in this manual.
A
B
C
D 3
SEC
E
F
will light up red when
4
5. Descaling
For safe & efficient operation of your Aurora appliance it is
important to descale regularly.
Untreated scale deposits prevent the element conducting
heat efficiently and may affect its performance.
The appliance will display the descale warning symbol when
the appliance requires the descale process.
Ensure the water tank is empty and the filter is removed
before starting the descale process.
Descale Procedure:
1. Fill water tank with 2L of 4%-5% vinegar solution.
2. Place jug under dispense nozzle.
3. Press and hold the descale warning symbol for 3 seconds.
4. The descale warning symbol will flash and the appliance
will run a descale process. Caution: Dispense solution
will be hot; around 60°C.
5. When the water tank is empty, refill with 2L of cold water
and press the descale warning symbol again.
6. The appliance will run a cleaning cycle. Caution:
Dispense solution will be hot; around 60°C.
7. The descale warning symbol will turn off once complete.
8. Re-insert the Aqua Optima filter after descale process is
complete.
9. The appliance is now ready to use.
Note:
• To abort the descale process, press the dispense button.
Unless the process is run completely the de-scale indicator
will not be reset and the appliance will continue displaying
descale icon.
6. Installation
The appliance comes with two plug types, one for UK and
one for EU, the correct plug should be used and inserted
into the plug socket.
WARNING: PLEASE DO NOT DISASSEMBLE THIS
APPLIANCE YOURSELF. ELECTRIC ELEMENTS WILL BE
EXPOSED AND THERE IS A RISK OF ELECTROCUTION
POSITIONING OF APPLIANCE
• Do not install this appliance in a very damp or hot place or
near heat source.
• Place the appliance on a flat and even surface.
• Install the appliance in a dry place to avoid damage,
moisture or rust.