Texi Zorro 100 Manuel D'utilisation page 14

TEXI Zorro 100 operation manual
Warning!
Nobody is allowed to command a machine.
Failure to observe the control cable can result in personal approval and permanent
damage to the device.
Read the operating instructions and the general safety instructions and safety instruc-
tions before us
Technical specification
Knife Size
Cutting height
Noise
Weight
5 speed
maximum power
tension
Basic operations
1.Switch on the machine: press the power switch, the light is on (red) - this means that
the machine is working.
2.Speed setting: press once, 5-step speed, from 800 to 1400 rpm.
3.LED light: Press continuously (about 3 seconds) to turn on the LED light. The same
should be done to turn off the lights.
Danger:
Before you make technical settings (e.g. changing the knife) of the motor, pull out the
mains plug and wait until the operating indicator lamp goes out.
ATTENTION:
The device must be switched off before any technical work (such as changing the blade,
changing the grinder).
For the machine to work properly, the discs must always be well sharpened, without chip-
ping, and kept clean.
14
Diameter 110 mm
27 mm
<55 dB
1,3 kg
800/950/1100/1250/1400 rpm.
250 W
230 V