Deuba monzana DBHK011 Mode D'emploi page 7

If there is reason to believe
that safe operation is no lon-
ger possible, the device is to
be put out of operation and
secured against unintended
operation. Safe operation is no
longer possible if the device
shows visible damages, no lon-
ger works, was stored under
unfavorable conditions for a
long period of time or was sub-
ject to considerable transport
stress.
Children aged from 3 years
and less than 8 years shall
only switch on/off the appli-
ance provided that it has been
placed or installed in its in-
tended normal operating posi-
tion and they have been given
supervision or instruction con-
cerning use of the appliance
in a safe way and understand
the hazards involved. Children
aged from 3 years and less
than 8 years shall not plug in,
regulate and clean the appli-
ance or perform user mainte-
nance.
Installation
Before use the base must be installed. The device
may not be used differently.
Assembly of the heater
Before using the heater, the feet (supplied
separately in the carton), must be fitted to the
unit. These are to be attached to the base of
the heater using the 4 self-tapping screws pro-
vided, taking care to ensure that they are located
correctly in the bottom ends of the heater side
moldings.
www.Deuba24online.de
Operation
Convector heater with thermostat (Model:
DBHK011)
Choose a suitable location for the heater, taking
into account the safety instructions above. In-
sert the plug of the heater into a suitable socket.
Turn the thermostat knob fully in a clockwise
direction to the maximum setting. Turn on
the heating elements by means of the rocker
switches on the side panel. When the heating
elements are on, the switches will illuminate.
For maximum heat output both switches should
be on. When the desired room temperature has
been reached, the thermostat knob should be
turned slowly anti-clockwise until the thermostat
is heard to click off and the lights on the element
switches are seen to go out. After this, the heater
will keep the air temperature in the room at the
set temperature by switching on and off auto-
matically.
12 13 www.Deuba24online.de
Convector heater with thermostat and timer
(Model: DBHK002)
All the above instructions for model DBHK011
also apply to model DBHK002. This model is also
fitted with a 24hr timer.
This Timer has 96 segments around its circum-
ference, each segment being equivalent to 15
minutes of time. With the aid of this timer it is
possible to preset the time and duration of the
period(s) that it is desired the heater will oper-
ate, in any 24hr period.
Timer Operation
The centre of the timer has a 3 position slide
switch.
In the central position (denoted by the clock sym-
bol) the timer will switch the heater on and off at
times set by the segments, (see setting the timer,
below).
The position denoted by the "I", is a timer over-
ride position. The timer will continue to run but
power will be fed continuously to the heater.
This enables the heater to be on all the time if
1: Switch 1
required. In the position denoted by the "O", the
timer continues to run but no power is fed to the
2: Switch 2
heater.
3: Thermostat
Setting the Timer
Ensure the slide switch on the timer is at the mid
position next to the clock symbol. Rotate the
outer ring of the timer in a clockwise direction
until the current time is lined up with the arrow
pointer, i.e. if the time the timer is being set is 8
pm, rotate the outer ring until the number 20 is
in line with the arrow pointer.
Set the time the heater is required to run by pull-
ing the segments around the outer ring forward
appropriate to the running period(s) required.