GE VE700 Manuel D'installation page 12

DIP switch 1: Control voltage (CV)
On: "Active High" provides the standard Aritech logic with "Active High"
logic to enable Walk test and Day/Night (Latch) inputs.
Off: "Active Low" provides "Active Low" logic to enable Walk Test and Day/
Night (Latch) inputs.
DIP switch 2: Chime (fig.
The detector can distinguish the direction of the intruder during day time.
Disable by setting the detector to Chime Off. When the chime is On, the
detector will trigger an alarm when the intruder moves right-to-left or left-to-
right across the curtains.
Note: If the Day/Night terminal is not used and the chime is On, the chime
will be On both during arm and disarm (Day/Night) mode.
DIP switch 3 : Chime direction (fig.
On: Alarm when an intruder walks from left-to-right.
Off: Alarm when an intruder walks from right-to-left.
(Stand with your back to the detector to determine left and right directions.)
DIP switch 4: LEDs
On: Enables both LEDs on the detector at all times.
Off: Puts both LEDs under the control of the Walk test and Armed/
Disarmed input when the system is disarmed.
3. Aligning the beam and walk testing the
detector
A) Using VE710 alignment tool: (fig. c)
1. Insert the VE710 in the sub-frame with the On/Off switch facing the
floor.
2. Connect to the COM port.
3. Turn on the VE710.
The laser spot indicates the product alignment (Fig. c A). If this spot
4.
on the wall veers from the centre of the desired detection area 1 m
from the ground, then loosen the base fixation screws (Fig.
use the three adjustment screws in the base to realign it to the centre,
as shown in Fig. c B. When the spot is correctly realigned, retighten
the base fixation screws.
5. Remove the alignment tool and replace the cover.
WARNING! Do not look into the laser beam.
The VE710 laser is classifed by IEC60825-1 as a Class 2
laser. Consequently the output power is less than 1 mW.
The eye's blinking reflex is fast enough to prevent any
permanet damage to the eye.
)
)
- 10 -
) and