Top Assembly - Uline H-4989 Mode D'emploi

Figure 1
Figure 2
Figure 3
PAGE 2 OF 6
ASSEMBLY CONTINUED

TOP ASSEMBLY

1. Using 24 wood screws, attach legs to the under side
of the tabletop (5) through pre-drilled holes.
(See Figure 1)
2. Set bench assembly upright and recheck all nuts,
bolts and screws for tightness.
MAPLE TABLETOP FIELD JOINT ASSEMBLY
1. Lay top sections with field joint slots facing up on a
smooth, non-marring surface to protect top sections
from damage. (See Figure 2)
2. Push top sections together so surface sides are flush.
3. Place a tite joint fastener in each field joint opening.
(See Figure 3)
4. Using a 7/16" wrench, snug the tite joint fastener so
that both top sections are clamped together. Align
the faces and edges to be flush before completely
tightening the Field Joints. Gently adjust each
section with a piece of wood and rubber mallet to
avoid damage to the tabletop, then finish tightening.
5. Before turning tabletop over, continue to Top
Assembly instructions on page 1.
1-800-295-5510
uline.com
0721 IH-4989