Table des Matières
Publicité
3.
Install the Wall Bracket
Hole Location
Emplacement des orifices
Lugar para el orificio
Run a finger around the inside of each flange to make sure the setscrew is flush
with the surface so the curtain rod can be inserted all the way.
Back the setscrew out if needed.
Position a flange over the mounting holes.
Secure the flange to the wall with the #8 x 1-1/2" wood screws provided. Do not
install the other flange at this time.
NOTE: Ensure the setscrew (located on bottom of flange) does not protrude beyond
the inside surface of the flange.
Slide the appropriate end of the shower curtain rod into the installed flange.
While holding the rod in place, slide the curtain rings onto the rod.
Place the uninstalled flange onto the opposite end of the rod.
Align the flange over the mounting holes and secure with the wood screws.
Tighten the setscrews in each flange.
Installer le montant mural
Passer un doigt autour de l'intérieur de chaque bride pour s'assurer que la vis
d'arrêt est à ras de la surface de manière à ce que la tringle de rideau puisse être
insérée complètement.
Faire ressortir la vis d'arrêt si nécessaire.
Kohler Co.
All manuals and user guides at all-guides.com
1-1/2" (3.8 cm)
Hole Location
Emplacement des orifices
Lugar para el orificio
Flange
Bride
Brida
Curtain Rod
Tringle
Varilla de cortina
7
Woodscrews
Vis à bois
Tornillos para madera
105286-2-A
Publicité
Table des Matières
