Package Contents; Hdmi Connection; Maintenance And Cleaning - Avtek TS 7 Mate Notice D'utilisation Abrégée

Package contents

• Quick guide manual
• Styluses ×2
• Wireless remote control
• Power supply cable
Connecting an external PC and the touch function
1) Connect the VGA cable (15 pin) to the VGA connector and to an external computer.
Plug the headphones' cable to the computer and the audio input on the monitor.
Alternatively you can use the HDMI connector.
2) Connect the USB cable to an external computer and the monitor terminal.
3) Connect the power supply cable.
4) Turn on an external computer (set the touch controller).
5) Press , to turn on the power.
6) Press INPUT to determine the appropriate connector as the image source.

HDMI connection

1) Connect the HDMI cable to the HDMI port on the external device.
2) Connect the power cable and turn the device on.
3) Press , to turn on the power.
4) Press INPUT to appoint an HDMI port as the image source.
Touch based service menu
To display the menu:
drag up the screen with your finger or stylus, starting from the centre of the screen, just
above the lower frame.

Maintenance and cleaning

Please stick to the following guidelines to maintain maximum performance of the monitor.
Before cleaning disconnect the device from the power source.
For cleaning of the device use only a soft, slightly damp cloth.
Do not clean the screen using chemical cleaning agents.
Do not apply cleaning agents directly on the surface of the device.
If the monitor is not used for a long time
In this case, please disconnect the device from the power supply to prevent possible
surges created during a storm.
WARRANTY
Avtek products are covered with European warranty.
For more details please visit www.avtek.eu/warranty.
• USB cable
• HDMI cable
• WiFi / Bluetooth module
Full version of this manual is available for download at www.avtek.eu/download
4