Calibration Interval; Battery Replacement - koban KMT-01 Mode D'emploi

KMT-01
VOLTAGE AND CONTINUITY TESTER
7. Maintenance
When using voltage testers in compliance with the instruction manual, no particular maintenance is required. If functional
errors occur during normal operating, our service department will check your instrument without delay.
8. Cleaning
Prior to cleaning, remove voltage test from all measurement circuits. If the instruments are dirty after daily usage, it is
advisable clean them by using a damp cloth and a mild household detergent. Never use acid detergents or dissolvents for
cleaning.
After cleaning, do not use the voltage tester for a period of approx. 5 hours.

9. Calibration Interval

the voltage testers must be calibrated periodically and checked by our service department at regular intervals to ensure the
specified accuracy of measurement results. We recommend a calibration interval of one year.

10. Battery Replacement

If no signal sound is audible when short-circuiting the test probes, proceed with the battery replacement.
1. Completely disconnect voltage tester from the measurement circuit.
2. Remove discharged screw,battery cover and batteries.
3. Replace by new batteries, two type "AAA" (UM4 R03) by respecting correct polarity.
4. Close the battery cover and re-screw the screw.
53 www.grupotemper.com