Samsung NX58 565 Serie Manuel D'installation page 26

Installation instructions
Step 7. Assemble the surface burners
CAUTION
Do not operate the surface burners without all burner parts in place.
Model NX58*565***/
NX58*751***
Model NX58*560***
Precise Simmer Burner (RR)
Flat surface
26 English
Install_NX58H56_DG68-00524A-13_EN+MES+CFR.indb 26 Install_NX58H56_DG68-00524A-13_EN+MES+CFR.indb 26
All manuals and user guides at all-guides.com
1. Position surface burner heads on top of
the surface burner manifolds as shown
at right. The electrodes will fit into the
slot in the bottom of the heads. Make
sure the surface burner heads are flat
and parallel with the cooktop.
2. Place the matching size caps on top of
each surface burner head.
NOTE
The caps on Precise simmer burner
(RR) and inside Dual Burner (RF) can be
interchangeably used.
Concave line
3. Place the left, center, and right surface
burner grates on the cooktop. The edges
of the grates should match up with the
edges of the cooktop.
Step 8. Check the ignition of surface burners and oven burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1. Push in and turn the control knob for
2. After the burner lights, turn the control
3. Repeat steps 1 and 2 to check the
Place food in the oven after preheating
if the recipe calls for it. Preheating is
important for good baking results. After
the oven has reached the desired cooking
temperature, it will beep 6 times.
that surface burner to the LITE position.
The "clicking" sound indicates the
electronic ignition system is operating
properly. The burner will light in about
4 seconds, after the air has been purged
from the supply line.
knob to the desired setting. The
"clicking" sound will stop and the flame
height will change from Max. to Min.
during turning the control knob.
operation of each surface burner
insuccession.
NOTE
2020-10-13 2020-10-13 11:50:34 11:50:34