Philips Sonicare 3000 Serie Mode D'emploi page 13

Using your Cordless Power Flosser
To remove the nozzle, press the nozzle release button
and pull the nozzle from the handle.
Before turning on the device, point the nozzle tip
1
at the sink. Press the on/off button on the handle
to turn on the Cordless Power Flosser. Allow water
to spray into the sink. Turn off the device once
water dispenses from the device.
2 Place the nozzle tip in your mouth. Lean over the
sink and partially close your lips over the nozzle tip
to avoid splashing. Leave enough space to allow
water to flow from your mouth into the sink.
3 Press the on/off button on the handle to turn on
the Cordless Power Flosser.
4 With the Cordless Power Flosser turned on:
a Position the nozzle tip just above the gum line
at a 90° angle.
Note: For the Quad Stream nozzle press gently so
that the nozzle tip is in contact with the gum line
and the teeth.
b Starting from your back teeth in your upper or
lower jaw, slide the nozzle tip along the gum
line and pause briefly between each tooth.
13
English