After Use - Ibiza COMBO210 Manuel D'utilisation

CONNECTION OF A PERSONAL MUSIC PLAYER TO THE 7/8 STEREO INPUT:
a. Turn down the "MASTER VOLUME" control.
b. Connect the output of the player to the "7/8" input of the mixer via a 3.5 mm stereo Jack.
c. If your player is fitted with an output gain or volume control, set that control to "7". Increase the value until you have
reached a sufficient level to drive the COMBO210
d. Increase the MASTER VOLUME gradually until you have reached the desired volume.
MONITOR OUTPUTS: You can connect these outputs to a variety of devices like a recorder, an active sub-woofer, another
power amplifier and speakers or another mixer.
a. Turn the "MONITOR OUTPUT VOLUME" control to "1".
b. Connect the MONITOR OUTPUTS (¼" PHONE or RCA) to the inputs of the device into which you want to plug the mixer.
c. Set the input level of the external device according to the manufacturer instructions.
d. Increase the "MONITOR OUTPUT VOLUME" gradually until you have reached the desired volume.

AFTER USE

Turn down the "MASTER VOLUME" control.
Turn the mixer off.
Disconnect the AC Power cable from the mixer and then unplug the cable from the mains outlet.
Disconnect the speaker cables from the mixer and then disconnect the speaker cables from the speakers.
Disconnect all other inputs (microphones, instruments or music players) from the mixer.
Store the cables in the storage compartment and fasten the latch.
To fasten the storage module or mixer module on the rear of the speakers simply reverse the process described in the
"Getting Started" chapter of the manual.
CAUTION:
Only use the system as a whole with all parts. Substituting different speakers could result in damage to the powered mixer
and could void your warranty. The powered mixer will not work with speakers whose impedance is lower than 8 ohms.
Do not daisy chain the speakers! No more than one 8 ohm speaker should be used on each speaker output. The speakers
are optimized for the powered mixer. The use of different speakers could result in bad performance.
Problem
No sound
Distorted sound
Sound is thin
Sound is deep-toned and booming
COMBO210
Cause
No power
Volume is turned down
Bad connections
Bad cables
Input overloaded
The system is overloaded
Too much treble
Not enough bass
Wrong speaker connection
Too high effect levels
Not enough treble
Solution
Check if the mains plug is properly
fitted into the wall outlet and into the
mixer.
Check if the wall outlet is powered
Check if the mixer is switched on.
Turn up the channel and the master
volume.
Check if the source device's volume is
turned up
Check all connections to the mixer
Check if the speaker cables are in good
condition.
The red PEAK Led is flashing or steadily
on, reduce the channel volumes and
press the MIC/Line switch.
If you use an external device, reduce
the volume of that device.
If the PEAK Leds and the LIMIT
indicator are red, turn the master
volume down.
Reduce the treble control
Increase the bass control
Check of all speakers are properly
connected
Reduce the Master effects Return
Increase the treble control
5