Makita HXU01 Manuel D'instruction page 9

To remove the attachment, loosen the lock lever, press
the lock button and withdraw the shaft.
NOTICE:
Do not tighten the lock lever without the shaft of the
•
attachment inserted. Otherwise the lock lever may
tighten the entrance of the drive shaft too much
and damage it.
Attaching shoulder harness
012761
Put the shoulder harness on your left shoulder by putting
your head and right arm through it. Keep the tool on your
right side.
After putting the shoulder harness, attach it to the tool by
connecting the buckles provided on both the tool hook
and the harness. Be sure that the buckles click and lock
completely in place.
Adjust the strap to the suitable length for your operation.
012762
The buckle is provided with a means of quick release
which can be accomplished by simply squeezing the
sides and the buckle.
WARNING:
Be extremely careful to maintain control of the
•
tool at all times. Do not allow the tool to be
deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could
result in serious injury to the bystander and the
operator.
MAINTENANCE
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before attempting
to perform inspection or maintenance on the
tool. Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
9