Wiring Diagram - Frecan LIFT LIGHT NT 90 Mode D'emploi

Procedure for fixing

Dimensional Drawings

Fix the hood as shown in the scheme
Connecting and fitting
Before connecting the appliance, check the household installation.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing: Do not trap the power cable and do not route it over sharp edges. If the
oven is a built-under type, route the cable on the rear corners of the oven to the
socket.
Electrical Connection
Connect the device to the mains and check the operation:

voltage, see the rating plate

connect adhering strictly to the relevant diagram
1. Brown
2. Blue
3. Yellow and Green

Wiring Diagram

INSTALLATION
The power cable must only be replaced by a
EN/1