Télécharger Imprimer la page

Hinkley Atlantis 1518CD -LL Guide Rapide

Publicité

Liens rapides

Note: cedar finish requires
different care. Please use the
below instructions for cedar
maintenance.
Silicone filled
Wire nut
Fixture Wire
Cedar Maintenance for CD finsh
Note: A thin clear coat, non-UV inhibiting lacquer
was applied at the factory to minimize naturally
occurring color change prior to installation. You may
maintain the wood in any means typical for a cedar
deck.
In order to maintain the cedar, remove the cedar
from the fixture.
1. Unscrew the two hex screws from the back of
the fixture
2. Slide the cedar up and off of the metal fixture.
HINKLEY
33000 Pin Oak Parkway
Bulb
Glass
Front
Screw
Plate
Hex Screw
Cedar
Metal
Fixture
Supply Wire
Avon Lake, OH 44012
Installation Instructions
Family: Atlantis | Item No.
1518CD -LL
 Start Here
Glass and Bulb Installation
1. With a Phillips screw driver, remove flat head screw on the
underside of the fixture.
2. Remove the front plate.
3. Insert the bulb into the socket.
4. Slide the glass in the glass track at the back of the fixture.
5. Once the glass is in place, re-assemble the front plate and
screw.
Luminaire Mounting
(For typical ground spike mounting)
1. To prevent electrical shock, disconnect the transformer
from the electrical supply before installation or service.
2. Run wire from luminaire through mounting hole in the top
of the ground spike.
3. Attach luminaire to ground spike by threading to mounting
hole in spike and locking it in place.
4.
Place spike in desired position and insert into ground until
the ange of spike is flush with ground.
5.
Strip the two wire leads from the luminaire and connect to
the main supply wire using the provided silicone filled wire
nut.
Note: Wire is to be protected by routing in close proximity to
the luminaire or fitting or next to a building structure
such
as a house or deck. Wiring should be buried a
maximum of 6 inches (15.2 cm) in order to connect to
main supply wire. The main supply wire must have its
length cut off within 6 inches (15.2 cm) from a building
structure, a luminaire or fitting.
(p)800.446.5539 / (f ) 440.653.5555
www.hinkley.com

Publicité

loading

Sommaire des Matières pour Hinkley Atlantis 1518CD -LL

  • Page 1 1. Unscrew the two hex screws from the back of the fixture 2. Slide the cedar up and off of the metal fixture. HINKLEY 33000 Pin Oak Parkway Avon Lake, OH 44012 (p)800.446.5539 / (f ) 440.653.5555...
  • Page 2 Afin de maintenir le cèdre, retirez le cèdre du luminaire. metal. 1. Dévissez les deux vis hexagonales à l'arrière du luminaire 2. Faites glisser le cèdre vers le haut et hors du luminaire en métal. HINKLEY 33000 Pin Oak Parkway Avon Lake, OH 44012 (p)800.446.5539 / (f ) 440.653.5555...