Publicité
Les langues disponibles
Les langues disponibles
1.
Remove the battery earth cable.
Remove side covering in the back of the car.
Open the entrance to the rearlight units.
2.
Drill a hole of 13mm in diameter just behind the socketplate of the towbar, or use an existing rubber grommet.
Remove carefully all metal particles around the hole and treat it with anti-rust paint.
Fit the rubber grommet in the hole.
3.
Route the wiringharness in the boot and lead the 8-pole end through the hole to the socket.
Pull the coverplate over the wiringharness.
Remove the contactholder from the socket and fit the wires as follows:
Trailer lighting:
Left turn signal
Rearfoglight
Earth
Right turn signal
Right taillight
Brakelights
Left taillight
Rearfoglight
4.
On the left side in the back of the car a white 8-pole connector is located.
Disconnect this connector and connect the wiringharness correspondingly.
In the middle under the hatshelf a 2-pole connector of the 3e brakelight is located.
Disconnect this connector and connect the wiringharness correspondingly.
Near the left hinge of the trunklid a 10-pole connector is located
Disconnect this connector and connect the wiringharness with the blue and grey wires correspondingly.
Fit the white wire to chassis earth.
5.
Reconnect the battery and check all electric functions, with trailer/caravan connected.
Reinstall disassembled parts.
©ECS2000
FITTING INSTRUCTIONS ELECTRIC WIRINGKIT TOWBAR WITH 12-N SOCKET UP TO
DIN/ISO NORM 1724
HYUNDAI SONATA 1993-
Partno.: HYU-009-B
Pin No.:
Wire colour:
1 (L)
yellow
2 (54-G)
blue
3 (31)
white 2,5 mm2
4 (R)
green
5 (58-R)
brown
6 (54)
red
7 (58-L)
black
8 (58-b)
grey
HYU-009-B-E
030200L
1
8
STOP
2
6
7
3
5
4
REVISIE 0
Publicité
