Using Your Juice Extractor - West Bend JUICE EXTRACTOR Mode D'emploi

Note: When assembling, you should not need to force any of the parts into place.
When the parts are properly aligned they will easily fit into place. Using excessive
force could damage the parts.
1. Place the appliance on a dry, level, heat-resistant surface, away from any edge.
2. Assemble the juice spout to the juicing bowl by placing the spout over the outlet
on the juicing bowl, with the hole facing down, and push until firmly seated. Place
the juicing bowl over the motor base aligning the juice spout over the notch in the
motor base and the grooves in the bowl with the locking arms. Press down until it
sits flat.
3. Place the micro-mesh blade into the juicing bowl. Rotate if necessary to align
with the motor coupler and press down firmly until the micro-mesh blade is tight,
level, and sits just below the top of the juicing bowl. CAUTION: There are many
small sharp blades in the bottom of the micro-mesh blade for proc essing the
fruits and vegetables. Use care when handling the micro-mesh blade to reduce
the risk of injury and/or damage to the appliance.
4. Center the juicer cover over the juicing bowl. Swing the cover locking arms up
into the grooves in the juicer cover and press down to snap in place. Make sure
the cover locking arms are locked securely into place on both sides of the juicer
cover. If the cover locking arms are not locked in place, the juice extractor will not
operate.
5. Slide the pulp container into place under the pulp outlet chute of the juicer cover.
6. Insert the food pusher down the juicer cover. Place a 5" cup below the juice spout
to collect juice. We advise placing a dishrag or paper towel below your cup to catch
any drips or possible spatter.
7. Plug cord into a 120 volt AC electric outlet only.
8. Your juice extractor is now ready to use.
9. Turn the juice extractor on for a few seconds using "P" (pulse) switch position to
ensure everything is functioning and all safety switches have been activated. If
the juicer will not turn on, unplug from electrical outlet, disassemble, and check
the alignment of all the parts to ensure they are properly positioned. Note: Do
not run the juicer dry for more than a few seconds as extended periods of dry
operation could cause damage to the juicer.
1. Place the appliance on a dry, level, heat-resistant surface, away from any edge.
Note: Do not operate this appliance where dust or flour can be suctioned up into
the vent openings, as this will cause damage to the appliance.
2. Assemble the juice extractor according to the "Assembling Your Juice Extractor"
instructions.
3. Prepare your fruit and vegetables by washing, and if necessary, cutting down to a
size which will fit into the feed chute of the juicer cover. Remove any tough skins,
pits, or seeds before juicing. Do not force any fruits or vegetables into the feed
chute, always make sure pieces will fit easily to prevent jamming.
4. Plug the cord into a 120 volt AC electric outlet only.
5. Turn the juicer on by selecting a speed; " I " (low) or " II " (high). Refer to the
"Juicing Guidelines" section of this manual for recommended speed selection.
English - 4
All manuals and user guides at all-guides.com
U Y J
SING OUR UICE
E
XTRACTOR