EGAmaster 58775 Manuel D'instructions page 36

TRACK MODE OPERATION
Note:
1. If appears, it means the wrench has been applied more than 110% of maximum
torque.
2. When 80% of the target torque is reached, the green LED will begin to flash and the alarm
tone will beep intermittently.
3. When 99.5% of the target torque has been reached, the alarm will change to a steady tone
and the green LED will stop flashing and stay on. The red LED will also illuminate.
36
START
(System initial)
Set Target Torque
Apply Torque
Current Torque Value
Reached 80% of Target Torque
Current Torque Value
Buzzer
Buzzer
Approaching Target Torque
*Note 1
*Note 2
Green LED
Reached 80% of
Target Torque
*Note 3
Red LED