Before Use - Supra SERENA Mode D'emploi

EN
(Original instructions)
PTC fan heater
Serena
DESCRIPTION
A. ON/OFF switch
B. Handle
C. Top panel control
D. Filter
E. Remote control
1. ON/OFF button
2. Timer
3. Power setting
4. Eco function
5. Temperature setting
6. Oscillation
7. Increase
8. Decrease
I. Led ON/OFF
II. Led power 1300
III. Led power 2000
IV. Led oscillation
V. Led Eco function
VI. Display
If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE
Fully extend the appliance's power cable
before each use.
Do not use the appliance if the on/off switch
does not work.
Do not move the appliance while in use.
Use the appliance handle/s, to catch it or move
it.
Do not use the appliance if it is tipped up and
do not turn it over.
Do not turn the appliance over while it is in use
or connected to the mains.
If you use the appliance in a bathroom or
similar place, unplug the appliance from the
mains when it is not in use, even if it is only for
a short while, as proximity to water involves a
risk, even if the appliance is disconnected.
Disconnect the appliance from the mains when
3-EN.indd 1 3-EN.indd 1
not in use and before undertaking any cleaning
task.
Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
Do not store the appliance if it is still hot.
Do not store the appliance on areas where the
temperature could be lower than 2ºC.
Make sure that dust, dirt or other foreign
objects do not block the fan grill on the
appliance.
Never leave the appliance unattended while
in use.
Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
Do not use the appliance to dry pets or
animals.
Do not use the appliance to dry textiles of any
kind.
CAUTION: User can't sleep when appliance is
under use; there is a risk of injuries.
INSTRUCTIONS FOR USE

BEFORE USE

Make sure that all products' packaging has
been removed.
Some parts of the appliance have been
lightly greased. Consequently, the first time
the appliance is used a light smoke may be
detected. After a short time, this smoke will
disappear.
To eliminate the smell given off by the
appliance when used for the first time, it is
recommended to have it on at full power for 2
hours in a well-ventilated room.
Prepare the appliance according to the function
you wish to use:
USE
Extend the cable completely before plugging
it in.
Connect the appliance to the mains.
Guide the appliance to direct the flow of air in
the desired direction.
Turn the appliance on, by using the on/off
switch (A).
Turn the appliance on, by using the on/off
button (1).
Select the desired power (3)
Select the desired temperature pressing on the
button (5) and adjusting it with the buttons (7)
4/4/22 10:38 4/4/22 10:38