Controls & Functions; Mode Button; Mains Connection - Subzero SZPA-P12 Mode D'emploi

CONTROLS & FUNCTIONS
1. DIGITAL MEDIA PLAYER
Enables you to play music through the speaker using a
variety of platforms.

MODE BUTTON

Change between different input modes
(USB, SD and Bluetooth)
PLAY/PAUSE BUTTON
(For USB and SD modes)
REPEAT BUTTON
For selecting play and repeat functions
SKIP
With short press / SCROLL with long press
DISPLAY SCREEN
SD CARD INPUT
USB DRIVE INPUT
BLUETOOTH WIRELESS RECEIVER
2. MIC GAIN
Increase and decrease the volume of the microphone
inputs (7). Note that this does not control the volume
of the wireless microphones.
3. LINE LEVEL
Increase and decrease the volume of the line input.
4. ECHO
Increase or decrease the amount of echo to be added
to the inputs.
5. MP3 VOLUME
Increase or decrease the level of the digital media
player input.
6. VOLUME
Increase or decrease the overall volume of the master
output of the speaker.
7. MIC INPUTS
2 x TS ¼ jack inputs suitable for low impedence
microphone signals. Note, this input does not support
microphones that require phantom power.
8. LINE INPUTS
Stereo RCA inputs suitable for high impedance line
level signals.
9. MIX OUTPUT
Stereo RCA output that provides a master output of
the speaker's mix at a line level signal.
10. GRAPHIC EQ
Control the frequencies of the master output at
100Hz, 330Hz, 1KHz, 3.5KHz and 10KHz. Boost or
limit the frequency by +/-12dB.
11. WIRELESS MICROPHONE VOLUME KNOBS control
the volume of the wireless microphones. Power to the
receiver can be switched on and off using the on/off
button.
12. BATTERY CHARGE INDICATOR
4 level indicator to show the battery life. The red light
indicator flashes when charge level is below 25%. At
this point, you need to recharge the battery as soon
as possible to continue use.
13 & 14. ANTENNAS
Receive radio frequency signals from the wireless
microphones. Be sure these are extended when in use
with the wireless microphones.
15. FUSE
This fuse is replaceable. Ensure to replace only with a
like for like fuse. Failure to do this could damage the
product. Before replacing, remove the unit from any
external power supply and ensure the mains plug is
not attached.

16. MAINS CONNECTION

Use only the power cable supplied with the product.
This power socket is fitted with a F1A at 250V fuse.
Ensure to replace only with a like for like fuse.
Failure to do this could damage the product. Before
replacing, remove the unit from any external power
supply and ensure the mains plug is not attached.
17. POWER SWITCH
This turns the device on and off. Note, if the power
switch is off but still connected to a mains connection,
the battery will continue to charge.
7
EN