Oster 5002 Manuel D'instructions page 7

All manuals and user guides at all-guides.com
• Wait for a short while until the Indicator Light goes on and off again.
• Set the Steam Select Dial in the desired steam level position (figure 3). You are now
ready to start steam ironing. The steam will be released evenly through seventeen
vents located in the soleplate for easier ironing.
• Use the Spray Mist feature to dampen fabrics with stubborn wrinkles.
®
• Press the Spray Mist ®
• The Shot of Steam ® feature provides an extra burst of steam for deep penetration of
stubborn wrinkles. The Shot of Steam
provided the tank is at least ¼ full of water and the Temperature Control Dial is set
within the steam band.
• Allow the iron to heat for approximately two minutes.
• Press the Shot of Steam
• Press the Shot of Steam
• The Shot of Steam ® feature is now ready for use. The Shot of Steam
be used continuously with just a short pause between shots. The Shot of Steam
feature is most effective with the Iron held in a horizontal position just above the fabric
being ironed.
• If the Water Reservoir runs dry, unplug the Iron and refill with water. The Iron may be
filled with water while it is hot. Note: It may be necessary to re-prime the pump before
using the Shot of Steam
(figure 3)
Spray Mist
(Models 5004, 5005 & 5706 Only)
button firmly to produce spray.
Shot of Steam
(Model 5005 & 5706 Only)
® feature can be used with dry or steam ironing
® Button several times to prime the pump.
® Button another three to four times in order to clean the unit.
feature again.
®
6
Feature
®
® feature can
®