Complete Installation Of Ap250; Status Light Reference - ooma AP250 Guide De Démarrage Rapide

Complete Installation of AP250

STEP 4
If you are installing the device on a desk,
set the device on a flat surface closest to
where you would like to have the strongest
Wi-Fi ® signal.
If you are installing the AP250 on the
ceiling, mount the device to the bracket by
lining up the mounting tabs on the bottom
of the AP250 with the corresponding tab
depressions on the bracket. Slip the tabs
under the edges of the tab depressions and
then rotate the device until it clicks into
place on the bracket.
Secure the device on the ceiling by
slipping the bracket keyholes over the
screw heads and sliding the bracket so
that the screws move into the narrow part
of the keyhole. Tighten the screws
to complete installation.
8
Mount Clip
Bracket
Mount
Clip
Connect Devices to a Wi-Fi
STEP 5
STEP
Using the information you noted in
more of the of the AP250's wireless networks.
Network
®
1, you may now connect wireless devices to one or
Status Light
Reference
Off – Device is powered off.
Flashing Amber – Device is
performing a firmware upgrade.
Do not power the device off during
this process.
Solid Amber – Internet connection
has not been established successfully
or the device is either booting up or
shutting down.
Solid White – Device is powered
on, connected to the network, and
operating normally. Wi-Fi
is active.
® connection
9