Power On The Ap150; Connect Devices To A Wi-Fi ® Network; Status Light Reference - ooma AP150 Guide De Démarrage Rapide

Power on the AP150

STEP 4
Plug the provided AC adapter in to the 48VDC port on the AP150 and connect the other end to a power source.
amber
The status LED will glow to indicate a successful power-up. The light will automatically turn green once
the device is fully operational and the Wi-Fi ® networks are available. This could take up to five minutes.
48VDC
PASS THRU
8
ETH1/POE ETH2 ETH3
STATUS
Connect Devices to a Wi-Fi
STEP 5
STEP 1, you may now connect a wireless device to one of the AP150's wireless
Using the information you noted in
networks to check that the device is working properly. If you have wired devices, you can connect their Ethernet
ports to any available Ethernet port on the bottom of the AP150.
Network
®

Status Light Reference

Off – Device is powered off.
Flashing Amber – Device is performing a firmware upgrade.
Do not power the device off during this process.
Solid Amber – Internet connection has not been established
successfully or the device is either booting up or shutting down.
Solid Green – Device is powered on, connected to the network,
and operating normally. Wi-Fi connection is active.
®
9