Unpacking Your Blower & General Assembly - ArmorAll AA20BW Manuel D'utilisation

UNPACKING YOUR BLOWER & GENERAL
1. Remove the contents from inside the box. Make sure you have all contents as listed on page
11.
2. Inspect the product carefully to make sure no breakage or damage occurred during shipping.
3. Do not discard the packing material until you have carefully inspected and satisfactorily
operated the product.
4. If any parts are damaged or missing, do not operate the product. Return it for replacement to
the retailer from which it was purchased.
WARNING:
If any parts are broken or missing, do not attempt to attach the battery pack or operate
the blower until the broken or missing parts are replaced. Failure to do so could result in
possible serious injury.
INSTALLING BLOWER TUBE
1
2
Align the wide end of the tube with the front opening on the blower. Attach tube to the blower,
turning clockwise to lock it into place (Fig. 1).
WARNING!
assembled to your product when you unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer installation. Use of a product that may
have been improperly assembled could result in serious personal injury.
ASSEMBLY
1
Do not use this product if any parts on the Packing List are already
7