Getting Started - Ruarkaudio R5 Guide De L'utilisateur

Getting started

1 Fit remote battery
Gently pull off the magnetic steel base and with the remote
face down, slide the battery (type CR2032) into the slot,
ensuring the flat side marked with + faces up. Replace the
steel base. Depending on model, you may also need to
remove the screw securing the plastic battery cover and then
sliding the cover out.
EN-8
2 Connect the aerial
Fit the telescopic aerial to the DAB/FM antenna socket on
the back of your R5 and gently tighten it using the supplied
spanner.
3 Connect to AC mains
Plug the mains power cord into the mains power socket on the
back of your music system and then plug it into an AC mains
outlet.
4 Switch on
Switch the mains power switch on the back of your music
system to the ON position. Your R5 is now in standby.
To turn your R5 on, press STANDBY on the controls on the
cabinet and the R5 logo will appear on the screen.
Please note that the remote may not work until it is paired with
the main system (see step 6).